W24s-75 Profile Bending Machines, also known as Section Bending Machine, or Angle Roll Bending Machines, are used to roll shapes out of solid bar, rod, tubing, pipe and structural sections, such as I beam, H beam, C beam, with the curvature always being in the same direction.

Generally, this series machines are constructed of a vertical standing or horizontal lie steel frame with the drive power input and transmission system on one side and the rolling section, which imparts the bending to the stock, being arranged on the other side.

 

¡øThree driven rollers

¡øbending rolls are high tensile alloyed forget steel, heat treated

¡øall welded steel frame, heavily proportioned and stress relieved

¡ødigital read outs for the position of the lower rolls

¡øThe three-roll double-pinch type uses one fixed roll and two moveable rolls. Rolls adjust to bend symmetrically or asymmetrically and pre-bend both ends of the work piece in a single pass. Bending distance-the distance between the tangent contact points of the rolls- increases with diameter rolled, broadening the capacity of the machine.

¡øguide rolls are hydraulic driven and adjustable in up/down

¡øShafts in alloyed steel, heat treated and grinded, mounted on long life grease lubricated self-alignment spherical roller bearings

¡øwith emergency stop buttons

¡øAll motors have corresponding breaker to protect for short circuit caused by over electricity 

¡øAll motors have corresponding heat relay as protection against overload